PDA

View Full Version : DIY improvement to my Manfrotto 055XPROB Tripod



Bear Dale
02-10-2010, 4:30pm
DIY improvement to my Manfrotto 055XPROB Tripod

It's always bugged me getting the lower legs level on my tripod so I took the rubber feet off and then dismantled the 3 lower legs from the tripod.

I turned them individually on a metal lathe and just very lightly scored them 1/8th of inch (just enough to remove the powder coating to bare aluminium) every 2" along the length of the three legs.

I then re-assembled them and now I have an easily seen visual marking to lock the three legs into and if it's too short or too long I can easily move all the legs to either the ring above or below.

Simple improvement, but a huge improvement to me.... making adjustments now is just so much easier.

etherial
02-10-2010, 6:26pm
Photo Jim?

ricktas
02-10-2010, 6:51pm
I rarely have my tripod on level ground, often it's on very uneven surfaces. I tend to extend two legs, set tripod up how I want it and then extend the third leg and just lock it into place when it hits the ground