User Tag List

Thanks useful information Thanks useful information:  2
Results 1 to 12 of 12

Thread: OMG......

  1. #1
    Member
    Join Date
    22 Apr 2011
    Location
    Adelaide
    Posts
    18
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    OMG......

    I took near 600 pics at an indoor wedding reception with my D7000 in Aperture priority and only got 60ish keepers.... I was using a 1.8 50mm lens, no flash. All pictures were either out of focus (Dof is practically zero I found at low fstop) or blurred (shutter speed was too slow at higher fstop)........ very nearly tossed the camera in the punch bowl... any advice would be appreciated...

  2. #2
    In Training MarkChap's Avatar
    Join Date
    09 Jan 2008
    Location
    Widgee,
    Posts
    2,587
    Mentioned
    2 Post(s)
    Tagged
    0 Thread(s)
    I think what Darren was trying to say was,

    That before actually taking the photograph you need to take note of what shutter speed you are achieving when in aperture priority mode and then adjust as needed by either increasing your iso to get a higher shutter speed or by adding some flash to the mix.
    If want to use natural light only then that only leaves ISO to control your shutter speed, you don't tell us what ISO you were using ??

    Depending on how close you were to your subject the DoF even at 1.8 should not have been so shallow as to be the sole cause of out of focus images.
    Smoke Alarms Save Lives, Install One Today
    I shoot Canon
    Cheers, Mark


  3. #3
    Member
    Join Date
    23 Jan 2011
    Location
    Goolwa
    Posts
    3,775
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    what ISO did you have it set at?

    If you are indoors with no flash it is probably better to use a high ISO, even with the aperature wide open.

    What aperature did you have it mainly on? Was it always about 1.8 or smaller? I don't think wide open would be too good though, as it wouldn't give you a good dof and is harder to get an area which you want to be sharp (eyes especially as it could be only the ears or the nose in focus if the focus is not spot on). With people moving around I think it would be harder too with a wide aperature. The blur with the smaller aperature (higher number) can be corrected by using a higher ISO (which would make the speed faster). I have learnt that to take photos whilst hand holding your camera, use the same (or a bit faster with crop sensor cameras) number as the lens. You used a 50mm, so your speed should be approx. 1/60 or more to safely hand hold. Works for me.

    Don't forget, even pro's have duds! Maybe others who have done Weddings or Events can help out better than I.
    Monika
    Equipment: Canon 60D, Nikon FE, Nikkor 50mm 1.8 lens, Fancier FT-662A tripod, 18-55mm kit lens, 55-250mm kit lens, 30mm 1.4 Sigma lens, LR4, PS Elements
    Check out my Flickr photos ... http://www.flickr.com/photos/missmonny/
    ... and then you can like me on www.facebook.com/PhotoByMB or see my shop on http://www.redbubble.com/people/msmonny



  4. #4
    Administrator ricktas's Avatar
    Join Date
    24 Jun 2007
    Location
    Hobart
    Posts
    16,846
    Mentioned
    12 Post(s)
    Tagged
    1 Thread(s)
    Post some of the photos in the members photos forums and let us critique and guide you. The best way to learn is to fail and get advice, then use that advice to improve. Failing teaches you what not to do, next time.
    "It is one thing to make a picture of what a person looks like, it is another thing to make a portrait of who they are" - Paul Caponigro

    Constructive Critique of my photographs is always appreciated
    Nikon, etc!

    RICK
    My Photography

  5. #5
    Member
    Join Date
    23 Jan 2011
    Location
    Goolwa
    Posts
    3,775
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quote Originally Posted by Pudda View Post
    ... any advice would be appreciated...
    I am sorry Kiwi but this is what he said. Yes, he wanted to throw the camera but probably due to frustration. He probably thought he was doing everything right and found out most of the images were useless.

    Oh, and sorry Pudda, I presume you are a guy!!!
    Last edited by Ms Monny; 05-07-2011 at 10:23pm.

  6. #6
    Administrator ricktas's Avatar
    Join Date
    24 Jun 2007
    Location
    Hobart
    Posts
    16,846
    Mentioned
    12 Post(s)
    Tagged
    1 Thread(s)
    Quote Originally Posted by Ms Monny View Post
    I don't think that this is constructive. He is actually asking for help, isn't he??
    He is, but at the same time saying' very nearly tossed the camera in the punch bowl' suggests that he is blaming the camera, rather than the operator. Whilst Kiwi's comments are blunt, he has a point.

    We cannot help unless we see some photos with EXIF intact, so we can see exactly what settings were used and then we can guide the member with constructive advice on how he can gain control over the way his camera works. Without knowing all the information (and EXIF doesn't lie) we cannot help!

  7. #7
    Member
    Join Date
    12 Feb 2008
    Location
    Brisbane
    Posts
    7,830
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Post removed by kiwi.
    Last edited by kiwi; 05-07-2011 at 10:38pm.
    Darren
    Gear : Nikon Goodness
    Website : http://www.peakactionimages.com
    Please support Precious Hearts
    Constructive Critique of my images always appreciated

  8. #8
    Member Grumby's Avatar
    Join Date
    10 Apr 2011
    Location
    Lugarno, Sydney
    Posts
    134
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Just another thought on the focus aspect for you to consider, is what focus 'mode' you were using.

    The choice between manual and auto for me is mostly a no-brainer... I just can't see well enough through the viewfinder to cope with manual focus these days, so I generally let the camera do the work. Now, this is where the other focus mode decision may have an influence on your very shallow DOF images...

    My camera (Nikon D3000) allows me to use a tiny spot in the middle of the image to control focus (well, actually I can choose a tiny spot in any one of eleven positions around the image), or base the focus on a block that is about 1/4 of the size of the whole picture - but centered... or base it on an 'average' over the whole image. The bigger the area you give the camera to choose from, the greater the risk of it choosing the wrong thing within that area to focus on - especially if you are at f/1.8 and have minimal DOF. Personally, I tend to always use spot focusing and use that to focus specifically on a person's eyes, or the particular item that I want in focus, above all others.

    Having said that, even with an f/1.8 lens... the combination of indoor lighting, no flash and (assumed) ISO at 100, you are likely to be getting fairly slow shutter speeds, and being susceptible to camera shake... That is probably going to be the biggest contributor to your failures, I'm afraid.

    Increase the ISO (experiment to see what works for your camera - I won't take mine over 400 unless I really have to - but cameras with better sensors than my entry level camera can go to 1600 or better with minimal noise), use available light to the max by moving people where you want them instead of just accepting the light where they are, or consider using bounce flash...

    All sound advice, but often difficult to remember or put into practice in the heat of the moment ;-) I make exactly the same mistakes time and again. Still, even though it was disappointing, at least with digital, you didn't have to get over 500 negatives printed to find that they were no good - imagine the cost!
    Grum
    Last edited by Grumby; 05-07-2011 at 11:10pm.

  9. #9
    It's all about the Light!
    Tech Admin
    Kym's Avatar
    Join Date
    15 Jun 2008
    Location
    Modbury, Adelaide
    Posts
    9,632
    Mentioned
    23 Post(s)
    Tagged
    0 Thread(s)
    Indoors with no flash is hard work.
    The D7000 has the same sensor as my K-5 and can deliver good low light results, but you really have to experiment and practice.
    • shoot raw for a start, you can pick up details in PP that JPEG loses
    • use up to ISO 12,800 but not higher
    • use around f/4 if you can to have some DoF
    • try to keep your shutter speed @ at least 1/80th
    • use a tripod or monopod to reduce camera shake, or learn to brace and hold your camera steady
    • learn to finger roll the shutter for smoothness



    Eg: http://www.ausphotography.net.au/for...-April-52-2011
    Last edited by Kym; 05-07-2011 at 11:35pm.
    regards, Kym Gallery Honest & Direct Constructive Critique Appreciated! ©
    Digital & film, Bits of glass covering 10mm to 500mm, and other stuff



  10. #10
    Member
    Threadstarter

    Join Date
    22 Apr 2011
    Location
    Adelaide
    Posts
    18
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    true..... I'm glad I went through the painful experience as I learnt a lot in the process..... i will post some photos soon...I cannot blame the camera, it will always be the operator
    Last edited by Pudda; 11-07-2011 at 10:28pm.

  11. #11
    Member
    Threadstarter

    Join Date
    22 Apr 2011
    Location
    Adelaide
    Posts
    18
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    thanks for the advice.....

  12. #12
    Way Down Yonder in the Paw Paw Patch jim's Avatar
    Join Date
    27 Jun 2007
    Location
    Loei
    Posts
    3,565
    Mentioned
    2 Post(s)
    Tagged
    0 Thread(s)
    How many posts are missing from this thread?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •